Liteguide Controller AE1000

Overview Feature Specification Product Catalog

Overview

The Liteguide Controller AE1000 carries out EPC （Edge Position Control） through a combination of Photoheads （PH16B） and Ultrasonic Sensor （UH01）, CPC （Center Position Control） through a combination of Photoheads and Autowide Sensor （AWE280 etc.） and LFC （Line Follower Control） through a combination of LH19 and LH110.

Feature

Liteguide Controller AE1000 is the successor to the previously well established AE900E and AE900L controllers.
This single type can be connected to Nireco standard sensors which has been used with the AE900E or AE900L controller.
（Some sensors may need to be used with a preamp）
Can be used directly coupled with electrical actuators K12 and K61. Can also be connected to the K80 series through use of a driver.
Has 2 systems, a sensor input stage and a shift input stage, which can be switched for use.
Uses a larger LCD display than previous models with a white backlight making it both easier to see and allowing for verification of a greater amount of information.

Specification

Power Supply Voltage		AC100 to 240V 50/60Hz ±10%
Power Consumption		300 VA (inrush current 100 A 10 ms typical (200 V))
Power Fuse		250V AC, 3.15 A (time-lag type)
Ambient Operating Temperature		0 to 50°C
Ambient Operating Humidity		35 to 85% RH or lower (no condensation)
Vibration Resistance		3.5 mm, 1 G, 3 to 150 Hz, three-directions (1hour)
Power supply Noise		2.5 kVp-p, normal mode, common mode 50 ns, 1μs width
Usage atmosphere:		Area with no water, flammable or corrosive gases, and little dust.
Mass		Approximately 5 kg
IP Class		IP30

고객창구

요청 및 문의사항은 이 양식을 사용하십시오.

요청 및 문의 양식은 여기

Tokyo +81-42-660-7358

Osaka +81-6-6190-5550